Linksys WAP54GP Bedienungsanleitung PDF herunterladen (Seite 29)

Chapter 5: Configuring the Wireless-G Access Point with Power Over Ethernet

The AP Mode Tab

Wireless-G Access Point with Power Over Ethernet

The AP Mode Tab

On this screen you can change the Access Point’s mode of operation. In most cases, you can keep the default,

Access Point. You may wish to do this if you want to use the Access Point as a wireless repeater to extend the

range of your wireless network. You may also wish to do this if you want to use the Access Point as a wireless

bridge; for example, you can use two Access Points in Wireless Bridge mode to connect two wired networks that

are in two different buildings.

AP Mode

The Access Point offers three modes of operation: Access Point, Wireless Repeater, and Wireless Bridge. For the

Repeater and Bridge modes, make sure the SSID, channel, and security settings are the same for the other

wireless access points/devices.

MAC Address

The MAC address of the Access Point is displayed here.

Access Point. The Mode is set to Access Point by default. This connects your wireless PCs to a wired network.

In most cases, no change is necessary.

If you want to let the Access Point’s signal be repeated, then click the checkbox next to Allow wireless signal to

be repeated by a repeater. Enter the MAC addresses of the repeaters in the MAC 1-3 fields. Repeaters can be

another access point or the Wireless-G Range Expander (model number: WRE54G).

Change these settings as described here and click Save Settings to apply your changes, or click Cancel

Changes to cancel your changes. Click Help for more information.

Figure 5-12: AP Mode Screen

IMPORTANT: For Wireless Repeater and Wireless Bridge modes, the remote access point must be a

second Linksys Wireless-G Access Point with Power Over Ethernet (model number: WAP54GP) or a

Linksys Wireless-G Exterior Access Point with Power Over Ethernet (model number: WAP54GPE). The

Access Point will not communicate with any other kind of remote access point.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 66 67

Keine Kommentare

Linksys WAP54GP Bedienungsanleitung Seite 29