Linksys WAP54GP Bedienungsanleitung PDF herunterladen (Seite 14)

Chapter 4: Connecting the Wireless-G Access Point with Power Over Ethernet

Overview

Wireless-G Access Point with Power Over Ethernet

Chapter 4: Connecting the Wireless-G Access Point with

Power Over Ethernet

Overview

This chapter explains how to connect the Access Point for setups.

Connections for Setup

1. Attach the Access Point’s antenna.

2. Connect your Ethernet network cable to your network router or switch. Then connect the other end of the

network cable to the Access Point’s Ethernet port.

3. If you are using Power Over Ethernet (POE), proceed to the following section, “Placement Options.”

If you are not using POE, then connect the included power adapter to the Access Point’s Power port. Then

plug the power adapter into an electrical outlet. The LEDs on the front panel will light up as soon as the

Access Point’s powers on.

Proceed to the following section, “Placement Options.”

Figure 4-1: Connect the Ethernet Network Cable

Figure 4-2: Connect the Power

NOTE: The Bridge features Power Over

Ethernet (POE) support. POE technology allows

a POE adapter (also known as a power injector,

power hub, or inline power device) to supply

data and power to an Ethernet device using a

single Ethernet network cable. To use the

Bridge’s POE feature, follow the instructions

for your specific POE device.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 66 67

Keine Kommentare

Linksys WAP54GP Bedienungsanleitung Seite 14