Linksys WRVS4400N Bedienungsanleitung PDF herunterladen (Seite 66)

Chapter 6: Setting Up and Configuring the Router

VPN Tab

Wireless-N Gigabit Security Router with VPN

VPN Tab

IPsec VPN

Use this screen to create VPN tunnels between the Router to the remote Router. All Linksys Routers with IPsec

VPN support can be used as a remote Router (e.g. RVS4000, WRV54G, RV042). The Router supports VPN tunnels

using IPsec (IP Security) technologies. You can create, delete, or modify a VPN tunnel on this page.

Select Tunnel Entry. Select a tunnel to configure or create a new tunnel.

Delete Button. Click this button to delete the selected tunnel.

Summary Button. Clicking this button shows the settings of all existing tunnels.

IPsec VPN Tunnel. Select Enable to enable this tunnel.

Tunnel Name. Enter a name for this tunnel, such as “Anaheim Office”.

Local Security Group

Local Security Group Type. Select the local LAN user(s) behind the Router that can use this VPN tunnel. This

may be a single IP address or Sub-network. Notice that the Local Security Group must match or cover the other

router's Remote Security Group.

IP Address. Enter the IP address on the local network.

Subnet Mask. If the Subnet option is selected, enter the mask to determine the IP prefix on the local network.

Remote Security Group

Remote Security Group. Select the remote LAN user(s) behind the remote gateway who can use this VPN tunnel.

This may be a single IP address, a Sub-network, or any addresses. If Any is set, the Router acts as responder and

accepts request from any remote user. Notice that the Remote Security Group must match or cover the other

Router's Local Security Group.

IP Address. Enter the IP address on the remote network.

Subnet Mask. If the Subnet option is selected, enter the mask to determine the IP prefix on the remote network.

Figure 6-41: VPN - IPsec VPN

Figure 6-42: VPN Tunnel Summary

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 133 134

Keine Kommentare

Linksys WRVS4400N Bedienungsanleitung Seite 66