Linksys WRVS4400N Bedienungsanleitung PDF herunterladen (Seite 52)

Chapter 6: Setting Up and Configuring the Router

Wireless Tab

Wireless-N Gigabit Security Router with VPN

Wireless Connection Control

This screen allows you to configure the Connection Control List to either permit or block specific wireless client

devices connecting to (associating with) the Wireless Router.

Wireless Connection Control

Enabled/Disabled. Enable or disable wireless connection control. The default is Disabled.

Connection Control

There are two ways to control the connection (association) of wireless client devices. You can either prevent

specific devices from connecting to the Wireless Router, or you can allow only specific client devices to connect

to the Wireless Router. The client devices are specified by their MAC addresses. The default is to allow only

specific client devices.

Wireless Client List

Instead of manually entering the MAC addresses of each client, the Wireless Router provides a convenient way to

select a specific client device from the client association table. Click this button and a window appears to let you

select a MAC address from the table. The selected MAC address will be entered into the Connection Control List.

Connection Control List

MAC 01-20. Enter the MAC addresses of the wireless client devices you want to control.

Change these settings as described here and click Save Settings to apply your changes, or click Cancel

Changes to cancel your changes. Help information is displayed on the right-hand side of the screen.

Figure 6-27: Select MAC Address from Wireless

Client List

Figure 6-26: Wireless - Wireless Connection

Control

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 133 134

Keine Kommentare

Linksys WRVS4400N Bedienungsanleitung Seite 52