Linksys BEFW11S4 Bedienungsanleitung PDF herunterladen (Seite 7)

EtherFast

Wireless Access Point + Cable/DSL Router with 4-Port Switch

A dynamic IP address may change every time your computer connects to the

network.

DHCP (Dynamic Host Configuration Protocol) DHCP is software that automati-

cally assigns IP addresses to client stations logging onto a TCP/IP network.

DHCP eliminates having to manually assign permanent IP addresses to every

device on your network. DHCP software typically runs in servers and is also

found in network devices such as Routers.

Connecting Your Hardware Together and Booting Up

Once you are sure that you have the above values on hand, you can begin the

Installation and Setup of your Wireless Access Point + Cable/DSL Router.

1. Power everything down, including your PCs, your Cable or DSL modem

and the Router.

2. Connect a Network cable from one of your PCs’ Ethernet ports to one of

the LAN Ports on the back of the Router. Do the same with all the PCs you

wish to connect to the Router. (LAN Port 4 will become inactive if you use

the Uplink port.)

3. Connect the network cable from your Cable or DSL modem to the WA N

port on the rear of the Router.

4. Connect the power-supply cable to the Power port on the rear of the

Router, then plug the supplied AC power cable into a power outlet.

• The Power LED will illuminate green as soon as the power adapter is

connected.

• The Diag LED will illuminate red for a few seconds while the Router

goes through its internal diagnostic test. The LED will turn off when the

self-test is complete.

5. Power on the Cable or DSL modem. Verify that the power is on by

checking the Link LED in the WAN column on the front of the Router.

The Link LED will be illuminated if the power is on and the modem is

ready.

Connecting the Wireless Access

Point + Cable/DSL Router to Your

Network

Overview

Unlike a simple hub or switch, the setup of the Wireless Access Point +

Cable/DSL Router consists of more than simply plugging everything together.

Because the Router acts as a DHCP server, you will have to set some values

within the Router, and also configure your networked PCs to accept the IP

Addresses the Router chooses to assign them.

You will need the following values from your ISP in order to install the

Wireless Access Point + Cable/DSL Router:

• Your broadband-configured PC’s fixed Internet IP Address (if applicable)

• Your broadband-configured PC’s Computer Name and Workgroup Name

• Your Subnet Mask

• Your Default Gateway

• Your Primary DNS IP address

Whoever installed your broadband access should have left this information

with you. If not, call your ISP and they will be able to supply you with it.

About Static & Dynamic IP Addresses

Static IP Addresses A static IP address is an IP address permanently assigned

to computer in a TCP/IP network. Static IP addresses are usually assigned to

networked devices, which are consistently accessed by multiple users, such as

Server PCs, or print server. If you are using your Router to share your cable

or DSL Internet connection, contact your ISP to see if they have assigned

your home a static IP address. You will need that address during your Router’s

configuration.

Dynamic IP Addresses A dynamic IP address is an IP address that is automati-

cally assigned to a client station (computer, printer, etc.) in a TCP/IP network.

Dynamic IP addresses are typically assigned by a DHCP server, which can be

a computer on the network or another piece of hardware, such as the Router.

}

Only if applicable

Instant Broadband

Series

1 2 3 4 5 6 7 8 9 10 11 12 ... 34 35

Kommentare zu diesen Handbüchern

Keine Kommentare

Linksys BEFW11S4 Bedienungsanleitung Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Linksys BEFW11S4